Okay i have built this new system and im having a little trouble with my CD Writer. The way my system is set up is this-
P4 1.6 Ghz
512 MB Ram
30 GB Hard drive connected to primary IDE on master
Toshiba 16x DVD drive Connected to Secondary IDE on master
16x10x40 Yamaha CD writer connected to Secondary IDE on Slave
Ahead Nero Burning Software
Now heres my problem-
When I try to do anything involving writing CD's- Copying, burning music CD's Etc. I cannot burn at over 8x speed or else it will fail. The error Messages i get are
Invalid Write State then,
Could Not perform endtrack
Now the Writer performs flawlessly when writing at 8x speed or below, just anything above just doesnt work. What could possibly be wrong?
P4 1.6 Ghz
512 MB Ram
30 GB Hard drive connected to primary IDE on master
Toshiba 16x DVD drive Connected to Secondary IDE on master
16x10x40 Yamaha CD writer connected to Secondary IDE on Slave
Ahead Nero Burning Software
Now heres my problem-
When I try to do anything involving writing CD's- Copying, burning music CD's Etc. I cannot burn at over 8x speed or else it will fail. The error Messages i get are
Invalid Write State then,
Could Not perform endtrack
Now the Writer performs flawlessly when writing at 8x speed or below, just anything above just doesnt work. What could possibly be wrong?