Hello all,
I have a problem when trying to switch from "data mode" to "command mode". I do the following steps":
1. Select Modem
2. Select "Modem Command Mode"
3. atd<number> (for data call)
4. After the call is accepted on the remote phone I get:
CONNECT 9600
OK
5. Send "+++" sequence to switch to command mode.
6. Now the problem is that procomm exit the command mode, and the connection is released instead of being suspended. (i cannot send any commands to the terminal only if I select again "Modem Command Mode")
How is it possible to send "+++" without procomm exiting the command mode.
I appreciate any ideas.
Thanks!
I have a problem when trying to switch from "data mode" to "command mode". I do the following steps":
1. Select Modem
2. Select "Modem Command Mode"
3. atd<number> (for data call)
4. After the call is accepted on the remote phone I get:
CONNECT 9600
OK
5. Send "+++" sequence to switch to command mode.
6. Now the problem is that procomm exit the command mode, and the connection is released instead of being suspended. (i cannot send any commands to the terminal only if I select again "Modem Command Mode")
How is it possible to send "+++" without procomm exiting the command mode.
I appreciate any ideas.
Thanks!