Hi, I got a MICS 5.0 w/ PRI, so far every thing looks fine, my routes are fine, destinatin code also fine, and calls are going out, but some time I notice that only one chanel will be in use and maybe two chanel and when another call is place on the pri it shows "no free lines", or "normal release" and no calls go out.
Then I remeber that another system, another MICS 5 w/PRI that I was programming about 6 months ago, in maintenace section under module it shows (card 1:23 loop or line) and when state key is pressed, it shows whatever lines is busy at that point. Now in this system I can't get the 23 lines showing on that section only shows (card 1: 1 loop or line) I don't know if this have to do with my problem,
ANY IDEA?
Thank you
Then I remeber that another system, another MICS 5 w/PRI that I was programming about 6 months ago, in maintenace section under module it shows (card 1:23 loop or line) and when state key is pressed, it shows whatever lines is busy at that point. Now in this system I can't get the 23 lines showing on that section only shows (card 1: 1 loop or line) I don't know if this have to do with my problem,
ANY IDEA?
Thank you