Problem dialing LD call using 1010XXX, on T1 PRI 1

[nezc1969]

I have a route to the local PSTN on the Meridian Opt11 with an acod XX that I need to dial 1010XXX to get long distance access to the carrier, I realize that all digit are sent when I seize a channel from the route but the Dchannel is not sending all 1010XXX, then I got the message from PSTN saying the call can not got thru as dialed, I suspect is a problem with the DChannel configuration but not have idea how to change it to allow it to sent all digit, if someone can help it will be very appreciated Example:

.trac 278
ACTIVE TN 021 0 00 03
ORIG 021 0 00 03 0 MCR 0 278 2616
TERM 007 23 TIE RMBR 6 46
DIAL DN 6810101230115058832455
MAIN_PM DIAL AUX_PM COMPLETE
TALKSLOT ORIG 10 TERM 10
QUEU NONE
CALL ID 0 103

---- ISDN PRA CALL (TERM) ----
CALL REF # = 23
BEARER CAP = VOICE
CALL STATE = 4 DELIVERY
CALLING NO = 278
CALLED NO = 230115058832455

 

[Reusser]

May be a problem using ACOD - have you tryied adding 1010 as a spn and dialing ac1 or ac1?

 

[ichabob]

Depending on what type of PRI you are using, the telco may not expect or allow certain digits. With an NI2 PRI and the DMS-100, translations are required for LD and INTL calls. The DMS will not expect 011 with INTL call, the TON will be sent as INTL and used.. Also digits 1+ may not be allowed unless their options are setup to. If the Channels are up in LD 60 and DCH are EST in LD 96, your config will not affect the translations of digits. Contact the telco and see if they expect 101XXX for casual dialing.