kevinmidnight
Programmer
Greetings fellows, I've been working with BCM50 since Rls 3.0 and I've never come across this issue. The problem is the following:
I'm trying to configure a BCM50 R5 with an expansion module with a Digital Trunk Module installed as a T1 for lab test. I know you must configure the parameters under the Telephony Resources/ Module Details window to specify if it is AMI SF or B8Z but, the Module Details is not showing up!! (I left a screenshot so you guys know what am talking about).
The expansion license is installed, the connection cables between the Main and Expansion were tested with a Fluke DSX-5000 and are ok, I've changed the Expansion unit with a new one, changed the DTM also, tried a new power supply for both the main and the expansion unit with no success...
Anyone has come across this bug with BCM50?
Please let me know asap.
Thanks in advance
I'm trying to configure a BCM50 R5 with an expansion module with a Digital Trunk Module installed as a T1 for lab test. I know you must configure the parameters under the Telephony Resources/ Module Details window to specify if it is AMI SF or B8Z but, the Module Details is not showing up!! (I left a screenshot so you guys know what am talking about).
The expansion license is installed, the connection cables between the Main and Expansion were tested with a Fluke DSX-5000 and are ok, I've changed the Expansion unit with a new one, changed the DTM also, tried a new power supply for both the main and the expansion unit with no success...
Anyone has come across this bug with BCM50?
Please let me know asap.
Thanks in advance