Problem after installing SP2 on NW6

[reili]

After insalling SP2, I got this PROBLEM I can't access the tree i get this error message -622 invalid transport. I can't log in to the server at all.

 

[Provogeek]

Post a copy of your DSREPAIR log file; (one pass) Brent Schmidt CNE, Network +
Senior Network Engineer

Why do user go into a panic when a NetWare server goes down, but accept it as normal when a Windows server goes down?

 

[reili]

I had to remove sp2 and now things are working again.
So I'm a little bit worried, because I will try again


NetWare 6.00 Directory Services Repair 10210.29, DS 10320.29
Log file for server ".NFOSLO.netware.storgata.nf" in tree "NF_TREE"
Repairing Server Network Addresses
Start: Tuesday, 3 September 2002 23.09.21 Local Time


Checking server: .NFOSLO.netware.storgata.nf
Found a Network Address Property on the server object and through DNS:
Address Type = TCP, data[6] = 192.100.22.3:524
ERROR: Adding a Network Address Property :
Address Type = IPX, data[12] = 000123450000000000010451
Address Type = TCP, data[6] = 192.100.22.3:524
Checking server address in Replica ID: 1, .[Root].
Checking server address in Replica ID: 1, .netware.storgata.nf
ERROR: Could not connect. Error : -622

*** END ***

 

[TheBoySmith]

The 622 normally shows when it cannot find an ipx address for a server. This is normally because it only has IP. The 622 is normal if no IPX is on the server being checked.

SP2 may upgrade you LAN drivers, try applying the sp without updating lan/disk drivers. There is an option to not do these updates when you install the SP. Lee Smith
Associated Network Services
Snr Systems Engineer
Lee.Smith@ANSPLC.Com