Printing problem with HPLJ3030 and CA Emulation session

[joniteravainen]

Hello all,
While printing report or invoice from as400 to LPT1 (printer emulation session) it leaves couple of letters/numbers out from left side.
It looks like print aligment is not correct. I checked printer setting from windows but I couldn't find anything that helps.
Reports with same layout print out correctly when using ipds based printing (axis printserver).
If I change the parameters on prtf where to start printing then this will move all prints also in ipds printing.
Can I change non-printable right margin to 0mm somewhere ?

Any ideas?

- Joni -

 

[joniteravainen]

Hello all,
I meant from the right side...
I should write L and R to my palms. LOL

- Joni-

- Joni -

 

[joniteravainen]

Hello all,

Solved the problem myself.
Basicly all that I did was that in HP's Web Control Panel I changed under printing settings option "Wide A4" from NO to YES.
Now printer believes that it is printing to A4+ size paper it gives me the 5mm needed.

- Joni -