Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Printed Document having blank 2nd Page 1

Status
Not open for further replies.

PCHD

Programmer
Nov 5, 2009
5
US
When I print the report in Crystal XI development it produces just one page; which is correct. However, when I print the report on INFOVIEW a blank second page is produced. How can I remove this superfluous page?
 
Easiest way I have found to fix this is to adjust the formatting on your report. If your fields are lining right up with the margins in developer, try pulling them inside the margins a little more. I usually try to leave a quarter inch blank between the edge of my last column and the right margin. You can also check to make sure that your page footer and report footer are not too wide.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top