PRIM setup

[TeleBug27]

Need some advice on how to set up the ISDN, When trying to call a station from a trend, it replies "Unallocated Number"

I take it the MFIM50B need to be set up for incoming call routing.

I have WEB access to the Admin, need some guidance

 

[SteveBUK]

Hi TeleBug27,

To Program Lines as DDI
Trans/PGM 140, CO Line Range – Dial digit 2 for DDI (DID), then Hold/Save

To Set DDI Conversion Type
Trans/PGM 145, CO Line Range, FK2 – Dial digit 2 (Use Flex DDI Table), then Hold/Save

Flex DDI Table
Trans/PGM 231, FK1 for Input, Enter last 3 digits of the DDI Number
FK1 – Name DDI, FK2 – Day Destination, FK3 – Night Destination
FK4 – Timed Ring Destination
Remember to Save your selection by pressing Hold/Save

DDI Busy/Error and No Answer Destination
Trans/PGM 167,
FK1 – Busy – Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)
FK2 – Error – Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)
FK3 – No Answer – Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)
FK4 – VSF Prompts – Set as Required
FK5 – Reroute Busy - Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)
FK6 – Reroute Error - Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)
FK7 – Reroute No Answer - Set as Required e.g. FK2 ATTD (Ring Assignment - PGM 144)

To Program Incoming Zero Insertion (ISDN Lines)
Trans/PGM 146, CO Line Range, F12 – Dial 1 to turn ON Incoming Prefix Insertion
Trans/PGM 146, CO Line Range, F16 – Dial 0 to Set My Area Prefix Code, then Hold/Save

Hope this helps
Regards
Steve

 

[martinhodge]

also you say PRIM the 50 b only supports BRI you will need the pri module if you want to run a isdn30 .