PRI trouble

[DTone]

Ok I have 2 0x32 with a t-1 between them. I got the PRI keycodes for both systems installed key codes, Program the Protacol for both, Enable both cards, and they do not work.
This is a point to point t-1 is that a problem? I called Qwest and they can Loop to both CSUs. But they do not see anything on the t-1 is there anyone out there that can point me in a direction to go?
alos did dest Codes and all that programming (Target Lines,Dest codes and Routes)
HELP Please!!!!

 

[stockwj]

With PRI service you must make sure that the D channel is working! Go in maintenance and check to see if the D channel is active. If not be sure that you have clocking set with one end as primary and ther other as secondary. Does your T-1 pass between two CO's? Qwest does not provide clocking on point to point T-1s.

John

 

[Norstarguru]

You would have to set the PRI's up as PRIVATE NETWORK not PUBLIC NETWORK, One side should be timing master, the other side should be PRIMARY. There is no provisioning on a point to point it is an open pipe, you decide what the programming is.

Norstarguru
john1@refurbphones.com