PRI Tie Trunk from Nortel CS1000 to Nortel CS1000 via Cisco 3800

[JarHead2078]

Can anyone tell me if a pri tie trunk can be configured between two Nortel CS1000's using a Cisco 3800 series router without using QSIG?

 

[hawks]

Can the CISCO accept the SL1 protocol?

 

[allenmac]

I believe you can configure the circuit in the cisco as a T1, then run whatever protocol you want on it from the Nortel endpoints.

 

[JarHead2078]

Hawks and Allenmac, I believe that cisco says that if you are provisioning isnd pri voice circuits that they only support qsig or nte3. I'm not really sure what nte3 is. Usually there is a work around for something like this, I was looking for the work around. We are trying to tie two systems together that are separated geographically by using our intranet.

 

[allenmac]

The cisco should not care what type of data is being carried. You are just provisioning a T1 from the WIC or VWIC of one 3800 to the same interface on a remote 3800. The PBX then takes the T1 (ESF B8ZS) signal and formats the pipe for use as a TIE PRI.

 

[mokeefe69]

this is what worked for me.

TYPE RDB
CUST 01
ROUT xx
DES CISCO
TKTP TIE
M911P NO
ESN NO
CNVT NO
SAT NO
RCLS EXT
VTRK NO
NODE
DTRK YES
BRIP NO
DGTP PRI
ISDN YES
MODE PRA
IFC ISGF
SBN NO
PNI 00002
NCNA NO
NCRD NO
CHTY BCH
CTYP UKWN
INAC NO
ISAR NO
CPFXS YES
DAPC NO
INTC NO
MBXR NO
DSEL VOD
PTYP PRI
AUTO NO
DNIS NO
DCDR NO
ICOG IAO
SRCH LIN
TRMB YES
STEP
ACOD 8181
TCPP NO
PII NO
AUXP NO
TARG
CLEN 1
BILN NO
OABS
INST
ANTK
SIGO STD
ICIS YES
TIMR ICF 512
OGF 512
EOD 13952
NRD 10112
DDL 70
ODT 4096
RGV 640
GRD 896
SFB 3
NBS 2048
NBL 4096
then the trunks

DES CISCO
TN 046 01
TYPE TIE
CDEN SD
CUST 1
TRK PRI
PDCA 1
PCML MU
NCOS 5
RTMB xx x
B-CHANNEL SIGNALING
TGAR 0
AST NO
IAPG 0
CLS CTD DTN CND ECD WTA LPR APN THFD HKD SPCD
P10 VNL
TKID
AACR NO
DATE




A wise man mends nets not swords

 

[JarHead2078]

Mookefe69,

I noticed that your IFC is ISFG (which is QSIG). The problem that I am having is that one of the switches does not have QSIG capability.