PRI Switch-Type

[phonedudeSr]

What is the commands for changing a PRI Serial Interface Switch-type

 

[andre2013]

isdn switch-type primary [4ess | 5ess | dms | ntt | ni]

 

[phonedudeSr]

is that the global command? how would I change it on individual serial interfaces as below?

interface Serial0/0/0:23
no ip address
encapsulation hdlc
no logging event link-status
no snmp trap link-status
isdn switch-type primary-ni
isdn incoming-voice voice
trunk-group 1
no cdp enable
!
interface Serial0/0/1:23
no ip address
encapsulation hdlc
no logging event link-status
no snmp trap link-status
isdn switch-type primary-ni
isdn incoming-voice voice
trunk-group 2
no cdp enable

 

[gnrslash4life]

conf t

int se0/0/0:23

isdn switch-type primary 5ess

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS

 

[phonedudeSr]

Great, do you have any knowledge with The Edgewater 4600? My client is converting from AT&T to Optimun Business service using a PRI. We are having difficulties establishing a clean connection. I have given them the framing that the 2951 interface is set for. B8ZS, ESF NI, but can't establish a link. The told us that we needed NI2, but NI is universal. I am hoping that they can change it to 5ess, also, it appears that they are limited on choices that they can change.

 

[gnrslash4life]

Is the gateway H323 or MGCP?

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS

 

[phonedudeSr]

it is a SIP gateway that the carrier is to configure to use a PRI. The customer is also using the internet.