PRI Setup Question

[MacMan11]

I am trying to setup a PRI on an 11c. I have an NTAK09,NTAK20 and an NTBK51 in slot 6. In following the NTP I add a DDB in LD73, then in LD 17 I add a DLOP with DLOP 6 24 ESF. So far so good. Then in following the NTP to add the D-Channel I use NEW DCH 15 under ADAN with CTYP MSDL. The next prompt asks for CDNO. The description says "Card slot number to be used as the primary DDCH/DCHI". The range is 1-9 so thinking this is THE 11c slot the card is in I enter 6 to get back:SCH3722 Added loops must be of the same type as DCHL(?). If I enter any other value from 1 to 9 it passes, so I play along. A little later the prompt is DCHL and the description says "Must match entry made for CDNO". Now the choices are again 1-9 and the only one I can not enter is precisely the choice I made for CDNO above. Is this an evil plot from Nortel or am I just plain crazy. Can anyone point me along to help rectify this? Siggghhh. TIA.

 

[geirendre]

You might need to add the PRI to the CEQU of the switch
LD 17
CHG TYPE CEQU
<CR>
PRI2 6

then try to add the DCH again...
Hope this helps.

 

[unkalary]

You in the states or oversears.? If states dont use PRI2. Anyway do you have device 6 already programed in the switch before you tried to program the DCH. If so change the device number and then try the DCH again. Also I dont remeber is the NTBK51 is a downloadable MSDL or not. If not a downloadable probably wont work.

 

[johnpoole]

the device number is a sw setting on the card and most techs try to match it with the slot number. to devices with the same nmuber will cause a restart since your manually picking an interupt.

CEQU
MPED 8D
SUPL 000 004 008 012
016 032 036 040
048
XCT 001
CONF 029 030 031 062

DLOP NUM DCH FRM LCMT YALM TRSH
PRI 002 24 ESF B8S DG2 01
MISP

ADAN DCH 3
CTYP MSDL
CARD 02
PORT 1
DES TIE81
USR PRI
DCHL 2
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
NASA NO
IFC SL1
SIDE USR
CNEG 1
RLS ID 23
RCAP
MBGA NO
OVLR NO
OVLS NO
T200 3


john poole
bellsouth business
columbia,sc