PRI DIN to DTMF for Legacy Equipment 1

[accconst]

I have an MICS currently equiped with 2 CLID cards. I will be switching from POTS service to PRI. I have an analog fax board that is capable of receiving DTMF tones and routing faxes based on these tones.

Can my MICS send calls received via PRI made to a specific block of numbers (say 555-555-52XX) to an analog port (I have an ASM) and then produce DTMF tones corresponding to the last 3 or 4 digits dialed?

 

[senk1s]

no

 

[accconst]

If I install a BRI card in the MICS and a BRI fax board in my server, can I send calls that come in via my PRI from the telco to my fax board via the BRI card and pass along DNI information?

 

[senk1s]

ive NOT used BRI ...but it 'is' a trunk, so it should be good

I've used on E&M, T1, PRI