PRI D Channel

[jspradlin]

Is there a way to monitor traffic on the D Chanel? I am trying to turn up a PRi with Millington Telephone Company and the CSU is loopable and Telco can pass patterern to CSU so the layer 1 is communicating but the D channel will not come up. I am not seeing any errors in Monitor.

 

[gknight1]

how many PRI's? you need 1 D channel per PRI. Is it a IP500 PRI24, if so i think you can use port 11 on the card for loopback, have them test to the IPO

 

[Bas1234]

In the monitor

ISDN Problems (T1 or E1 PRI connections)

Enable the following System Monitor settings:
• ISDN/Events/Layer 1
• ISDN/Events/Layer 2
• ISDN/Events/Layer 3
• ISDN/Packets/Layer 1 Send
• ISDN/Packets/Layer 1 Receive
• ISDN/Packets/Layer 2 Send
• ISDN/Packets/Layer 2 Receive
• ISDN/Packets/Layer 3 Send
• ISDN/Packets/Layer 3 Receive
• Call/ Packets/Extension Send
• Call/ Packets/Extension Receive
• Call/ Packets/Extension TxP
• Call/ Packets/Extension RxP
• Call/Packets/Line Send
• Call/Packets/Line Receive
• Call/Events/Targetting
• Call/Events/Call Logging
• System/Error
• System/Print
• System/Resource Status Prints



This will provide information about the ISDN line itself and any calls in progress. It will tell us things like the line is going down.

If the problem is with a specific ISDN line then the System Monitor can record info for a specific line only. This is done by entering an ISDN line number in the “Port Number” field. ISDN line numbers range from 0 – 8. The Line number is shown in the Configuration Lines List. A blank entry means all ISDN lines are monitored.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[jspradlin]

this is an IP406 with a single PRI

 

[dunham1]

Sounds like the provider has the Pri down or blocked.


The choices you make dicatate the Life you lead

 

[jspradlin]

Problem resolved. The provider of Millington Telephone has a DMS500 switch from Nortel and the T-1 was set to inactive in the switch.

Thanks for the comment dunham1