PRI Caller ID problem

[ssk1137]

Dear sir

We are using NEC ips 2000 with PRI (30 Juntion lines) when we are dialing... the only one number that is the first number in PRI is being displayed where as other junction numbers in PRI are not displayed in clip...Any one may please be given suggestion

regards

 

[belevedere]

Outbound CID is set up with CMD's 1212, 1213 and 5005.
EX: send out 505 555 2222 (2222 is the DID extension)
CMD 5005 de 00 de 505555 exe, this sets up the first 6 digits
CMD 1212 de 2222 de 00 exe, this tells the system which table for the extension to use in CMD 5005
CMD 1213 de 2222 de 2222 exe, this tells the system the last 4 digits to send out by extension.

 

[imeldesign]

I asked this question a few years ago..but this is what I have in my cheat book:
Go to CM 5005>00 through 14 and find one of these bins that = NONE. Or choose bin 1 or 2
Assign there, the 10 digit number you want to project to the network (XXX-XXX-XXXX).
Then go to CM 1213 for each of the stations and assign the bin number you programmed in CM 5005.


For instance my first two bin are:
01 is XXX-660
02 is XXX-662

Also make sure CM 1212 for those stations = last four digit of #. I use matworks MOC so:
F9
1213
F8
XXXX (ext #)
F8
bin#
F2

 

[ssk1137]

Thank you Mr.imeldesign i will come back after going thru your advise

sampath