PRI and Ground Start 2

[cas1437]

I have an ISDN PRI that is providing all the DIDs to my property. I also have five ground start pots lines going to the same switch. Do I need the ground starts? What is the easiest way to see how the ground starts and pri are progammed to be handled by the switch? I have been doing some reading but cannot seem to find these two questions being answered. Pardon my ignorance and thanks for the help.

 

[bhassell2000]

ld 21
ltm (list trunk memmbers)

will show what route each channel is assigned to. Then


ld 21
prt
rdb

to see what each route does

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[RickyPone]

You may have to print your rlb and look for the routes that ae associated with the cot/wat routes.

 

[GHTROUT]

If you dial 9 to get out, then those ground stat analog trunks are probably there as a backup to the PRIs. You need to look at call routing, which is done in BARS. Here is an example of BARS:

http://www.ghtrout.com/bars/

First do what bhassell2000 wrote, then to get a overview of what you need to print out in BARS, this is a good guide:

http://www.ghtrout.com/files/Print_Out_BARS.html

I think you want some backup to the PRI. But make sure you are using the PRI as a first choice for everything. Also make sure you can make 911 calls over it. I know that seems odd, but some "local" PRIs do not allow 911. I have seen it first hand.




--
Nortel Resources at GHTROUT.com World Famous!
--