Presentation of calling number on analogue phone display?

[esterix]

We have BC12 version on MD110, and ISDN PRI trunk with PSTN. On digital extensions we have presentation of every incoming call (from public exchange and from private extensions) on phone display.
But, is it possible to provide presentation of calling number on analogue extensions. If so, is this service going to be compatible with Panasonic phones that support display of caller number?

Is it enough to change our SERV parameter under ROCAP from 3101000001 to 3101000011, and ADC parameter under EXCAP from 000000001 to 010000001.

When we first installed MD110 we didn't have FAL1041997 (A-NUMBER-DISPLAY-ATS) among licences with 30 days free trial, neither on the list of System licences !?

If there is anyone who uses analogue extensions and have presentation of incoming call number on analogue phones, please explain what licences and what settings do we need.

 

[whosrdaddy]

Though the license is already available, this feature will be available from BC13, with the introduction of the new analog board (ELU34)

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[singhbrindisi]

Hi,

Check faq806-3305

Cheers,

""The truth about action must be known and the truth of inaction also must be known; even so the truth about prohibited action must be known. For mysterious are the ways of action""

 

[esterix]

Thanks singhbrindisi!

Still before we buy the license we are not sure will it work on our system.

FAL1041997 is listed among licenses (not allowed).

We have ELU29 board for analogue extensions - do we need to do PROM changes and what kind of changes.

D1 ICAT parameter (for A-number display)is available only for China Application System!