PPU for ipLDK-100 -> Rescuing the PMU/ASMU's of the MPB/MPBN

[doktor]

Hi all

I often get private mails concerning LG products. Sometimes the have common interests, like this:

You have maybe tried to upgrade the ipLDK-100 to a higher level of firmware, and suddenly (e.g. if the modem line (ISDN) has been disconnected), then the PMU or ASMU went defective?
An excellent board, PPU, exist to rescue PMU/ASMU.
PPU is for ipLDK-100 and it can "low level" copy firmware from one master PMU/ASMU to up to 4 receiving PMU/ASMU boards.
So, it can be used for fault correction of defective PMU/ASMU boards - it works everytime!
If you had an upgrade of the ipLDK-100 PMU/ASMU that failed, you just use the PPU to rescue it.

If it still exists, you should ask your country distributor how to order and buy it.

///doktor


///doktor

 

[doktor]

The PPU is just placed in the MPB slot of the ipLDK-100. A master PMU/ASMU is placed on the PPU in the appropriate slot. The same is done with up to 4 pcs of PMU or ASMU - receiving units. The master (or original) board (PMU or ASMU) should be copied to the same board type (PMU to PMU and ASMU to ASMU).
After 2-3 minutes the copying is finished - nice and easy.

///doktor

 

[pleskuk]

Ho doktor,

Thanks for this info. It's very good to know that such an option exists.

Best Regards,
Ivo

 

[Chamvari]

it's now Gold you can't get it anymore , i have one it helps in solving a lot irregularities on the PMU,asmu for all the IPldk systems.


Dial Tone shoul be There