[PP8600]Nedd command of to switch from MasterCPU to SlaveCPU

[xyCruiseryx]

Hi all,

When i have a opened Telnet connection to a passport 8600, i want to switch from master to slave cpu for administrating the slave cpu files about the dir command.


Is that possible or do i need a console connection ??

THX

 

[cbxmark]

Once connected to the master CPU try telneting to 127.0.0.6 if the secondary is in slot 6, or 127.0.0.5 if the secondary is in slot 5. Hope this helps

 

[xyCruiseryx]

Thanks for your answer,


i will try it out.......

 

[Jynxx]

From the master just type "peer telnet (without the quotes). You will have to log in again as you did on the master.