Powerpath not showing some paths.

[dandan123]

One of our servers was recently provisioned with 88 luns. This is on SRDF - R1/R2.

The R1 side is fine I can see both paths in powerpath for all luns.

On the R2 side some luns (around 36) show single paths. Solaris (format) shows both paths.

These are the commands I tried -
powercf -q
powermt -config
powermt -save
powermt -check

devfsadm -C -c disk

I also tried -

luxadm -e forcelip /dev/cfg/cx

Besides a reconfig reboot anything else I can try ?

 

[smishra]

Hi.
have u got any solution to this problem ? I guess reconfiguartion boot might have fixed this problem.

Thanks. Smishra