We've got a Poweredge 2600 Server and an APC Smart UPS. Have installed Powerchute, and it is configured to shutdown the server when Battery Life has almost run out. It is also set to restart the server when power has resumed.
Shutdown occurs normally, but when power comes back on, the server requires a manual power on. I did some research and it looked like there were supposed to be 3 BIOS settings on the Poweredge to Never start on power available, Always start on Power available, or resume last state. It appears that I need to make sure it is "Resume last state". When I go into setup on a reboot <F2>, I can't find this selection. Am I just being too dense here? Any help would be appreciated.
Shutdown occurs normally, but when power comes back on, the server requires a manual power on. I did some research and it looked like there were supposed to be 3 BIOS settings on the Poweredge to Never start on power available, Always start on Power available, or resume last state. It appears that I need to make sure it is "Resume last state". When I go into setup on a reboot <F2>, I can't find this selection. Am I just being too dense here? Any help would be appreciated.