Port Network &S8700

[dhibsystel]

I have an S8720 with 4 G650
2IPSI cards.

I want to use 2 port networks

each 2 G650 installed in location1
and the other 2 G650 in location2.

 

[4merAvaya]

If you do 'list cabinet' it will show you the existing PN configuration. You will need a MedPro/Crossfire board in each Port Network.

Kevin

 

[dhibsystel]

no I have not yet begining the installation.

I ask is it possible to dot it and how I can configure the 2 port network ?

PN1 and PN2.

 

[telecomturner]

not sure what you are trying to do........

but to build a PN you need some of the following

-g650
-ipsi
-medpro's or xfire
-clan
-tn771 (?) maintenance card
-if splitting cabinets you will need "bus terminator"

 

[Mitch672]

It has to be "designed" that way, whoever did the AVAYA ASD design would tell it "2 port networks", and you would have (4) Buss terminators, 2 short TDM cables, 2 MEDPRO's, and either (2) or (4) IPSI's, depending upon the reliability choses. You MUST have at least (1) IPSI, and (1) MEDPRO per port network, usually there would also be a TN711 maint/Test pack in each PN as well, and usually a CLAN and a VAL board as well.

Mitch


Mitch

AVAYA Certified Expert