Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Port 1 Problem on an Analog Expanion Module

Status
Not open for further replies.

kokolatas

IS-IT--Management
Nov 19, 2007
162
GR
IP 500 4.2.11
ANALOGUE ATM 16 6.2.11

There is one analog line connected on the first port of this analog module. When my customer calls outside the pbx and the call is connected at both ends, then after 11-14 seconds the call disconnects with a 'Disconnect from Destination End' Reason.

I plugged this line on another port and it works fine. I plugged ON this port an other line and it didn't work.

All the lines on this module has the same default programming.
This Module has at least another 4-5 analog lines on it which they work fine.


Strange, isn't it?Lol..Any ideas ?
Thanks...
 
Sounds like the port is buggered :)

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top