Point to point help!!!

[supafly2]

O.K. Here it goes. I have a point to point drop from the telco from office A to office B. All I want to do is connect the two. Seems simple enough to me, except I know little about router configuration. I've tried some posted setups and different configs and get no connection. I'm going to reset the router and start from scratch. Could somebody post a simple router A and B point to point config. A list for each. I know how to get the config programmed I'm apparently choosing the wrong settings. I would like something to compare.
I have 2 1720 cisco routers w/ 1- t1 dsu/csu in each. A dedicated line setup and ready to go. I don't have the telco info handy but the T1 installed for internet access is
Your frame-relay DLCI is: 211
Frame-relay LMI Type: ANSI
Encapsulation: Frame-Relay IETF
I am assuming this would be the same (minus the DLCI - 211) as the dedicated line.
Thanks in advance for any help. By the way, I'm out of time to get this working. Any info asap would be helpful.

 

[supafly2]

heres what I got so far:
Serial is up protocol is up

here is my current config both are just about the same.

hostname grif0000
!
enable secret XXXXXXXXXXXX
enable password XXXXXXXXX
!!
memory-size iomem 25
ip subnet-zero
no ip domain-lookup
!
cns event-service server
!
interface Serial0
description line to harp
ip unnumbered FastEthernet0
encapsulation ppp
no ip mroute-cache
!
interface FastEthernet0
ip address 192.114.115.199 255.255.255.0
no ip mroute-cache
speed auto
full-duplex
!
router rip
version 2
network 192.0.0.0
no auto-summary
!
ip classless
no ip http server
!
snmp-server engineID local 00000009020000021761B4CE
snmp-server community griffin RO
snmp-server community public RO
!
line con 0
transport input none
line aux 0
line vty 0 4
password XXXXXX
login
!
no scheduler allocate
end