Point 2 Point PRI

[mcrackin]

Has anyone done a point 2 point PRI with the Norstar or any other systems for that matter. I am in the need to have a point 2 point PRI circuit that is not going thru the CO. The systems are going to be about 300 meters apart. I have done point 2 point T1 with out any problems but never ISDN. I did not think that it would be a problem but never tried it.

Thanks again,

Richard S. McCranie
CoMatrix Southeast
richm@comatrix.com

 

[jerryreeve]

one discussion was on thread799-508295 and there are other threads out with discussions on setting up point-to-point. I had hooked this up in class a few years ago and i know it will work, you will end up getting a PRI enabler for each system. Ver 5.0 starts in with setting up networking and ver 6.0 improves on it.

Check out the installer guides, networking, chapter on this.

JerryReeve
Communications Systems Int'l
com-sys.com

 

[mcrackin]

That is exactually what I needed. I have done this repeatedly with T1 and I thought that it would be the same for the PRI. Just get the additional stuff needed to do the Networking part and you are in there.

Thanks again,

Richard S. McCranie
CoMatrix Southeast
richm@comatrix.com