Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Please suggest a configuration for 2 HDs , 1 CD-RW and 1 CD-R

Status
Not open for further replies.

zaidulon

Technical User
Jun 14, 2001
63
CA
I am planning to install 2 HDs , 1 CD-RW and 1 CD-R drive on my system (Win 98 SE, Celeron 900) . What would be the best arrangement if my priorities are fast HD access and CD to CD recording ?

I have in mind the following configuration :

Primary IDE :
Master : HD #1
Slave : CD-RW

Secondary IDE:
Master : HD #2
Slave : CD-R


Please comment or suggest other arrangements .

Thanks,
 
I would highly recommend putting the HD's on one IDE and the CD's on the other. It's not a very good idea to have CD's on the same IDE as you HD's because CD drives run slower, and therefore reduce the performance of your Hard Disks.

Primary IDE :
Master : HD #1
Slave : HD #2

Secondary IDE:
Master : CDRW
Slave : CD-R

I've got a DVD and CD drive on the same channel and it doesn't cause any problems when copying from one CD to another.

That's my personal preference! Hope it helps! :)
 
Thanks, xscape, for your kind input. Your comment softened my concern that putting CD-RW and CD-R on the same IDE channel may cause recording problem. It's encouraging to know that you have had no problem with your configuration. But in your case , do you have a recordable DVD or CD-RW? Thanks,
 
In my PC I've got a CDRW and DVD on the same channel (IDE 2). I was worried about copying from the DVD drive to the CDRW, but after talking to other people I tried it and haven't had any problems. It burns at full speed and I've had 1 buffer underrun out of about 50 CD's (and that was my fault for doing other stuff whilst burning). So I think that's a pretty good record.

Good luck with it! :)
 
It sounded very good to me. Thanks again ,xscape;

 
Hard drives on Primary IDE because they are MUCH faster,
Roms on the other.
I know when you start up it gives out a warning about to rom divices on one IDE channel but without say something like an IDE PCI controller card it's the best your gonna get! Martin
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top