I am currently using a pix 506 with a cable modem. I am getting the outside e0 IP from ISP DHCP server. I am trying to open the PIX to allow inbound traffic to IP 192.168.1.107 but have not had any luck.
Below is the important part of my current config:
PIX Version 5.3(1)
nameif ethernet0 outside security0
nameif ethernet1 inside security100
ip address outside dhcp setroute
ip address inside 192.168.1.1 255.255.255.0
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
dhcpd address 192.168.1.10-192.168.1.20 inside
dhcpd dns w.x.y.z ww.xx.yy.zz
dhcpd lease 99999999
dhcpd ping_timeout 750
dhcpd enable inside
---
I have tried all different types of static commands:
static (inside,outside) a.b.c.d 192.168.1.107
with all types of access lists and conduits but have not had any luck. Is this even possible to do with a cable modem and a single PAT address? Or have I just wasted a lot of valuable time??
Any help would be greatly appreciated!
Below is the important part of my current config:
PIX Version 5.3(1)
nameif ethernet0 outside security0
nameif ethernet1 inside security100
ip address outside dhcp setroute
ip address inside 192.168.1.1 255.255.255.0
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
dhcpd address 192.168.1.10-192.168.1.20 inside
dhcpd dns w.x.y.z ww.xx.yy.zz
dhcpd lease 99999999
dhcpd ping_timeout 750
dhcpd enable inside
---
I have tried all different types of static commands:
static (inside,outside) a.b.c.d 192.168.1.107
with all types of access lists and conduits but have not had any luck. Is this even possible to do with a cable modem and a single PAT address? Or have I just wasted a lot of valuable time??
Any help would be greatly appreciated!