Hi,
I've got a interface bundle config of the following using a uBR VXR 7246:
interface Bundle1
ip address 192.168.24.1 255.255.255.0
ip pim sparse-mode
cable arp filter request-send 3 2
cable arp filter reply-accept 3 2
cable dhcp-giaddr primary
cable helper-address 192.168.4.222
ipv6 address 2001:558:FF10:806::/64 eui-64
ipv6 address 2001:558:FF10:80D::/64 eui-64
ipv6 enable
ipv6 nd prefix 2001:558:FF10:806::/64 60 30 no-autoconfig
ipv6 nd prefix 2001:558:FF10:80D::/64 60 30 no-autoconfig
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ipv6 nd ra interval 5
ipv6 nd ra lifetime 30
But I was wondering how do I think ping the cable interface on the CMTS :
vxr7246#ping ipv6 2001:558:FF10:806::
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:558:FF10:806::, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
I've got a interface bundle config of the following using a uBR VXR 7246:
interface Bundle1
ip address 192.168.24.1 255.255.255.0
ip pim sparse-mode
cable arp filter request-send 3 2
cable arp filter reply-accept 3 2
cable dhcp-giaddr primary
cable helper-address 192.168.4.222
ipv6 address 2001:558:FF10:806::/64 eui-64
ipv6 address 2001:558:FF10:80D::/64 eui-64
ipv6 enable
ipv6 nd prefix 2001:558:FF10:806::/64 60 30 no-autoconfig
ipv6 nd prefix 2001:558:FF10:80D::/64 60 30 no-autoconfig
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ipv6 nd ra interval 5
ipv6 nd ra lifetime 30
But I was wondering how do I think ping the cable interface on the CMTS :
vxr7246#ping ipv6 2001:558:FF10:806::
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:558:FF10:806::, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)