I would default the programming with the button in the back
To default the configuration using the Reset button
1.On the rear of the control unit, press and hold the Reset button for between 10 to 30 seconds until the CPU led
changes to flashing orange.
2.When the CPU LED changes to flashing orange, release the button.
· If the CPU LED changed to red, keep the button held until the CPU LED changes to flashing green. Then
release the button and reattempt the process once the CPU LED has returned to steady green.
3.Wait for the reboot to complete before performing any other actions.
then when the system comes back up and discovers DHCP it will grab an IP address and you can connect to it via your PC / Laptop without having to set your IP address manually
Joe W.
FHandw, ACSS (SME), ACIS (SME)
“Quality is never an accident; it is always the result of high intention, sincere effort, intelligent direction and skillful execution; it represents the wise choice of many alternatives.”