blondboy71
Technical User
I have a CS1000E 5.0 System. It is connected through voip trunking to a bcm450. On trunk line 96 on the bcm450, I have a paging system attached. I am trying to dial from the CS1000E, to pick up line 96 on the BCM450. Here is what I have done so far. The extention range on the BCM450 is 4000 to 4199. On the CS1000E I have in NRS routing entries pointing 40 and 41 to the BCM450. On the BCM450, I have setup trunk line 96 to be in Line Pool C. In routing on BCM450, I made a new route 003, had it use line pool c, and in the destination codes, typed in 4199, set it to route 003, and put the absorbed length to all.
With the BCM Monitor/Line Monitor up for the BCM450, I dial 4199 off a phone on the CS1000E. I see a voip line blink, then the CS1000E phone displays release and try again.
I can call any digital phone or analog station from the CS1000E to BCM450, but not to that trunk. Please Help.
With the BCM Monitor/Line Monitor up for the BCM450, I dial 4199 off a phone on the CS1000E. I see a voip line blink, then the CS1000E phone displays release and try again.
I can call any digital phone or analog station from the CS1000E to BCM450, but not to that trunk. Please Help.
