We have a phaser 850 PD that had jamming problems. and as i found out on this form we needed to replace the maintenance tray and the clutch witch we did. and it now prints with out jamming. but it about 1/2 an inch to low and that last 1/2 an inch is off the page can anyone tell me how to fix this? Thank you all for the help so far and i hope you can give me some help on this one.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 850 DP out of alignment 1
- Thread starter Theredone
- Start date
-
1
- #2
check the paper tray and ensure the tray sensing plugs are in place on the right side of the tray. The tray should have 3 holes for plugs, the bottom one has a slide for transparencies. Using letter size paper you should only have the top hole with a plug in it.
- Thread starter
- #3
- Thread starter
- #4
i'm so stupid i tried what marty said i was sure that the plug was in the same spot it always was but when i moved it to the top it worked and is printing fine. i did have to tape it in dose anyone know what hte part# is for one of these i would like to order a new one.
- Status
Similar threads
- Question
