I have a phaser 850 with a broken piece that fell out of the printer when I opened the main paper tray. It is a silver bar with four gray rollers attached. It appears to fit on the front of the printer near or on the pick guide assembly. Both sides of the silver bar have a keyed tab, but one is wider than the other. It appears I can slide this mechanism back into place, but I'm not sure of that. Any help appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 850 broken piece identification 1
- Thread starter BobWerner
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question