Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 8400 error "04,024.45"
- Thread starter gdtek
- Start date
Straight out of the book: This fault code indicates a problem with the wiper. After homing the wiper, it asks for it to go to the PARK/LOCK position. If the wiper motion fails during mechanical initialization, to go to the correct position, this fault will occur.
1. Run and check Wiper Alignment test.
2. Run the Wiper Drive test.
3. Inspect the wiper drive system and wiper lock system for proper operation.
4. Inspect the head maintenance clutch for the presence of oil or contaminants.
5. Run the Head Maintenance Clutch test.
6.Replace the problem component.
Hope this helps!!!
1. Run and check Wiper Alignment test.
2. Run the Wiper Drive test.
3. Inspect the wiper drive system and wiper lock system for proper operation.
4. Inspect the head maintenance clutch for the presence of oil or contaminants.
5. Run the Head Maintenance Clutch test.
6.Replace the problem component.
Hope this helps!!!
- Status
Similar threads
- Locked
- Question
