Hello,
Some times after a hundred prints the inks sticks to the drum.
This is mostly when i print large quantities of the same full page covering picture. When on the duplex side that line/spot (at the side of the page) is not covered with ink the problem is not there. It is at the side of the thermal sensor. (i already cleaned it)
Can it be that my drum gets too cold at that sideline?
Could it be the solution to adjust the drum temperature with the Diags software?
What are the right temperatures anyway?
Thanks,
Melchior
Some times after a hundred prints the inks sticks to the drum.
This is mostly when i print large quantities of the same full page covering picture. When on the duplex side that line/spot (at the side of the page) is not covered with ink the problem is not there. It is at the side of the thermal sensor. (i already cleaned it)
Can it be that my drum gets too cold at that sideline?
Could it be the solution to adjust the drum temperature with the Diags software?
What are the right temperatures anyway?
Thanks,
Melchior