Hi there
I just visited a 8200 where it had the usual 15.0.45 error code. So i replaced the pre-heater assy. Now upon bootup when it tries to do its cleaning page, it jams just as it is entering the registration assy. The paper isnt marked or wrinkled etc. I have taken out the reg assy and blown out the sensors but no go. I have also checked the registration solenoid and that works fine. I checked the voltage to that solenoid but there is none. But im not sure if the sensors on the reg assy sends a signal to turn the solenoid on when the registration switch is actuated.
Any ideas?
Regards
John
I just visited a 8200 where it had the usual 15.0.45 error code. So i replaced the pre-heater assy. Now upon bootup when it tries to do its cleaning page, it jams just as it is entering the registration assy. The paper isnt marked or wrinkled etc. I have taken out the reg assy and blown out the sensors but no go. I have also checked the registration solenoid and that works fine. I checked the voltage to that solenoid but there is none. But im not sure if the sensors on the reg assy sends a signal to turn the solenoid on when the registration switch is actuated.
Any ideas?
Regards
John