Phaser 740 "Jam at Duplex unit, remove duplex unit" Error

[computerparter]

Does anyone have the part number for the U-shaped black plastic sensor that fits under the front of the paper tray on units without duplex? It's under the lower left access panel. Mine has broke off and when I try to place it back on the pins as xerox suggests, the error will not clear. I think it is an optical sensor. "8k" is stamped on the side.
Xerox wont give me the part #. Thanks...

 

[MDA2]

If I remember I will post the # for you in the morning.

 

[llettyharri]

Hi,
Did you ever get a reply to this message. My sensor has just broken off and I'm getting the same message. How did you sort it? By the way my sensor says 8G.

 

[jedwilli]

Folks - I just replaced that entire sensor board -- I'm still getting the same message. Any suggestions?