Phaser 650 Print Head Alignment

[betts939]

I have a Phaser 650N that had a bad printhead. I found one cheap on ebay so I bought it. Unfortunately, the person who removed it didn't know how to do the job properly and loosened the four alignment screws located next to the two removal screws.

Can I realign the print head myself? If so, how?

Thanks,


Rod

 

[betts939]

Oops! Sorry, I identified the printer incorrectly. It's a Phaser 860.

Thanks,


Rod

 

[CULTOFLON]

I would assume (you know what assuming can do) that you could use the same procedure as the Phaser 840 used. But you will need the adjustment kit to do so. If anyone knows a better way I'd like to know. Thanks Later