Phaser 350 1

[meaded]

Can anyone identify the code 05,002,42:4270

 

[marty5261]

This is a Y axis position failure which means the drum is not where it is supposed to be or is not moving at all. Check to see if something is blocking the drum movement. Check the position encoder on left side. Sometimes if teh encoder disk is not centered in the sensor it will not read teh disk and give that error. The encoder plugs into the I/O board under it so a problem may lie there. Hope this helps.

 

[meaded]

If the drum is not moving when is the first point it begins to move as soon as powerup? Is there an point you can check for lack of movement.