Phaser 340 Falut 04, 005. 44: 15791 1

[shafqath]

I have a Phaser 340 that is giving me a problem. It says Falut 04, 005. 44: 15791. Could anybody help me with this?

Thanks,
Shafqat Shah

 

[rolleye]

From looking through other posts here, and having the problem myself, I was able to determine that the fix is fairly simple.

Here is a quote from another thread...

Your error just needs a Drum Maitence Clutch replaced. Easy fix. Takes about 5 mins to do. part# 401-0710-01.. Cost about $19 (posted by MDA2)

You can order them new from Tektronix, or I exchanged some email with some other folks that have used ones for $ 10 + shipping. they have a web site

http://www.getthatpart.com

I ordered mine from Tektronix (long story). I have had an email
exchange with a Tek tech who said the fix is fairly simple, Take off the top cover and the left side cover (left side while looking at the printer) and you will see the cluth assm.

I will be doing mine when my part gets here.

Post here is you need soem help and I will try to respond.

Rolleye

 

[shafqath]

Thank you very much. It helped.

Thanks,
Shafqat Shah

 

[shafqath]

yes! phaser 350 is fixed we repalced solenoid switch thanks for tip.

Thanks!
shafqat shah

 

[TMart1]

4,005.44
(0x2405):
PC_DEV_FAULT_
DM_
CAM_ERR
Failure positioning drum maintenance cam during a drum
maintenance cycle: check drum maintenance cam solenoid,
clutch, home sensor, and related hardware.

last numbers are your printer's page count
==
have a manual on it in PDF if you ned help

God bless
Ted

 

[mtcs]

Ted

I could us the manual if you would email
it to me.

mortech at adelphia dot net

Thanks alot

Bob

 

[TMart1]

Contact me direct at TMart79050@aol.com and I can help

God bless
Ted

 

[ss69camaro350]

Is it possible for the clutch to just be jammed, etc? Or is it busted?

Thanks,

SS69camaro350