Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Phaser 340 error 24,018.17:0

Status
Not open for further replies.

nzr

Technical User
Jan 25, 2003
1
US
I just bought a Phaser 340 from ebay. The printer goes through the warmup and then starts flashing 24,018.17:0 and Service Required on the front panel.

Any tips would be helpful, and I could use a service manual.

Thanks
 
Error states the the engine is stuck during warmup, thermals will not stabilize.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top