Phantom Terminal Numbers

[11480]

I have Meridian Option 81-C, Release 23 PBX. I have Phantom terminal numbers (156.0.0 to 156.1.10). I want to add another Phanton terminal numbers bucause all Phanton terminals are used. Am I able to add another Phanton terminals and how?
Thanks,

 

[bigindian65]

156-1-11 0 thru 15 if I understand you correctly, can be built. Just add a 500 in ld 10 or 11 and the TN would be 156-1-11-0


Mato' Was'aka

 

[11480]

I am not able to add on 156.0.11.0. I tried and it's give SCH error.

Yhanks,

 

[bigindian65]

in ld 11
STAT 156 0 11 all 15 in use?

stat 156 0 12 any UNEQ? build on an UNEQ unit

Mato' Was'aka

 

[11480]

I get following error

REQ: new
TYPE: 500
TN 156 0 11 SCH0124
TN 156 1 SCH0123
TN

 

[bigindian65]

do the stat

Mato' Was'aka

 

[11480]

I am not able to do stat. see below.

PT0000
REQ: stat 156 0 11
PHANTOM LOOP
NPR665
TIM784 12:37 10/5/2010 CPU 0

REQ: !
>err npr665
>

NPR0665
This command is not valid on phantom loops, since phantom loops do not
=
physically exist.

Severity: Minor

*
REQ: stat 156 0 10
PHANTOM LOOP
NPR665

 

[11480]

See below.
REQ: new
TYPE: 500
TN 156 0 12 SCH0124
TN 156 1 SCH0123
TN
SCH0120
TN ****
OVL000
>*ld 20

PT0000
REQ: new*
REQ: !
>err sch0124
>

SCH0124
Card out-of-range (1-10).

Severity: Info

 

[bigindian65]

hmm, I can stat them. anyway, go to ld 97 and prt SUPL lets see what you have. If you want to add another one, you do it in ld 97 as well.

Mato' Was'aka

 

[bigindian65]

you have all 256 phantoms used on 156 0 ???

Mato' Was'aka

 

[allenmac]

Try going to LD 10, and enter the following:

REQ: new
TYPE: cardslt
TN 156 0 12

If the system accepts this command, then you should be able to program additional phantom TNs on 156.0.12.x