Phantom Cards

[JeremyParr]

I have a TN795 in a CMC for lab use. `list conf all` shows the boards I have installed, along with phantom boards in 01A06 and 01A07. They show up as "no board". If I `change circuit-packs` to delete them, I get the error: "Must remove translation on the board before changing circuit pack type". `list stat` and `list trun` are empty. The cards it thinks are there are TN2793 and TN2214. Is there any way to view any resources using these cards? Kinda like fstat in the unix world.

 

[JeremyParr]

Ok, so music on hold was set up to use the analog line card, that has been sorted out. If I do a 'display capacity` I see that there are three stations set up in the system. I assume they are on the phantom digital board. Can't seem to find them though.

 

[busster]

doing a list station or list extension does not show these?

 

[JeremyParr]

`list station` shows on station, and that is tied to port 01A0401, not the phantom board in 01A07. `list extension-type` shows one item, the extension on port 01A0401.

 

[busster]

How about list mark? Is it possible a port was marked as bad?

 

[JeremyParr]

no ports marked as bad.

 

[busster]

When doing the list con all, you see all "u's" beside the "no board" correct? No numbers?

 

[busster]

Nothing in list data?

 

[JeremyParr]

01A07 DIGITAL LINE no board t t t t t t t t
t t t t t t t t
t t t t t t t t

Nothing in `list data`

 

[busster]

t's" are there for TTI. What would happen if you turned TTI off under sys features, second page, then tried change circuit, and blanked the card out with a space?

 

[JeremyParr]

Turning off TTI changed to all "u"s, but the card is still showing up.

 

[busster]

and you still can not remove the circuit board by doing a change circuit, then blanking it out?

 

[JeremyParr]

Ok, sorry, had to remove the value of "B" in the "Sf" collumn before I could blank out the TN number. Everything seems to be happy now. Thanks!

 

[busster]

cool