PEStartPrintJob: Not enough Memory for operation 1

[MzKitty]

I just installed Seagate Info 7.5 and tried to run a scheduled report. It keeps failing with the following message:
PEStartPrintJob: Not enough memory for operation.

We are not going thru the web. Any help would be appreciated.

Cathy

 

[synapsevampire]

There are some known issues, such as:

http://support.crystaldecisions.com/library/kbase/articles/c2008969.asp

I used to get memory errors if I did not have a sufficiently sized swap file too, but I can't recall the settings, it's been too long since I played with SI.

-k

 

[gsomerville]

We had similar problems upgrading to 7.5. Try running the reports in design mode. If the reports run to completion then look at the formulas, as some of the functions perform differently (eg DTSDatetoTime).

If you have migrated to a new server as well as upgrading, it's possible for the report to still point to the old server location for the data source if Info SQL queries have been used for the source.

 

[rhinok]

There are a variety of causes for this error message. Check out the following Crystal Decisions knowledge base articles:

http://support.crystaldecisions.com/library/kbase/articles/c2009249.asp

("Not enough memory for operation" error when scheduling report based on query)

http://support.crystaldecisions.com/library/kbase/articles/c2009321.asp

(How to troubleshoot memory errors in Seagate Info)

~Kurt