Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PCUT Creation CTN630

Status
Not open for further replies.
carlssonlove

carlssonlove

Technical User
Aug 13, 2005
1
RO
Hello, I;m new to this forum, and i want to ask you something
i have Pcut Creation CTN630,with Artcut2002 software, and i have some problems. if i have win98 installed on my pc, and artcut installed it-s ok,the cutter will do its job.
If I have installed artcut on a WinXP support, there is a problem with my machine i tink, because it doesn't want to cut, and strage i-m not receiving any error message.
How shall I proceed to make my cutter work on WinXP, and another problem, how can i make it cut directly from Corel11
Thank you,
 
Sort by date Sort by votes
I can't answer this question but I think the subject came up on another forum I go on. Go to which is a forum for signmakers, primarily uk based but increasingly people from overseas drop in (all are welcome)If you find the answer perhaps you would post it here for others.
Alan
 
Upvote 0 Downvote
I had the same problem with my pcut machine. I found that the baud rate on my machine was set different from the settings on the program. Once I made sure that they were the same, there was no problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top