PBX/Intuity DCIU link cabling

[cmcdan1523]

What do I need to directly connect an Intuity to a Definity G3si. I already built the data module/comm link/processor channel in the PBX. Replicated the config in the Intuity DCIU link screen. Now the cabling information on the Avaya site is cryptic at best. Can I connect a straight RS232 cable? What is an IDI connector?
What is the easiest way to get these guys talking?

Thanks.

 

[mike144]

isolation Data Interface unit, com code 107422735, should be able to get from Avaya Supplier, you need the two cables that connect to it also. If this is a release 6 or below, you need a processor interface carde also.

 

[cmcdan1523]

Found one. Thanks