I have just patched a Solaris 10 Sparc system using suns recommended patch bundle and I get the following error when it is finished.
vc:/system/boot-archive:default (check boot archive content)
State: maintenance since Fri Jun 03 10:24:52 2005
Reason: Start method exited with $SMF_EXIT_ERR_FATAL.
See: See: /etc/svc/volatile/system-boot-archive:default.log
Impact: 48 dependent services are not running. (Use -v for list.)
svc:/network/rpc/gss:default (Generic Security Service)
State: uninitialized since Fri Jun 03 10:24:51 2005
Reason: Restarter svc:/network/inetd:default is not running.
See: See: gssd(1M)
Impact: 10 dependent services are not running. (Use -v for list.)
svc:/application/print/server:default (LP print server)
State: disabled since Fri Jun 03 10:24:51 2005
Reason: Disabled by an administrator.
See: See: lpsched(1M)
Impact: 1 dependent service is not running. (Use -v for list.)
upon searching the web I found a solution to it but it is only for x86 and not sparc.
So how can I rebuild this archive on Sparc bearing in mind sparc does not have th grub bootloader. How can I boot into failsafe mode and fix teh boot-archive??
Cheers
Steve
vc:/system/boot-archive:default (check boot archive content)
State: maintenance since Fri Jun 03 10:24:52 2005
Reason: Start method exited with $SMF_EXIT_ERR_FATAL.
See: See: /etc/svc/volatile/system-boot-archive:default.log
Impact: 48 dependent services are not running. (Use -v for list.)
svc:/network/rpc/gss:default (Generic Security Service)
State: uninitialized since Fri Jun 03 10:24:51 2005
Reason: Restarter svc:/network/inetd:default is not running.
See: See: gssd(1M)
Impact: 10 dependent services are not running. (Use -v for list.)
svc:/application/print/server:default (LP print server)
State: disabled since Fri Jun 03 10:24:51 2005
Reason: Disabled by an administrator.
See: See: lpsched(1M)
Impact: 1 dependent service is not running. (Use -v for list.)
upon searching the web I found a solution to it but it is only for x86 and not sparc.
So how can I rebuild this archive on Sparc bearing in mind sparc does not have th grub bootloader. How can I boot into failsafe mode and fix teh boot-archive??
Cheers
Steve