passport 8600 qos

[mucka]

hi guys , anyone seen this one , when setting a port on 8600 for "diffserve enable" & " core port" we get the error message DISABLE PORT BEFORE CHANGE DIFFSERVE STATE !!

even though you disable the port ,we still get the error.

this happens on some ports but not on others , Its not a blade thing ,same on others.
its not a tagging thing or a MLT issue.

Any ideas ??

thanks in advance

mucka

 

[Wookie27]

Check that the port you are trying to enable diffserv on is not a member port of an IP filter already.

If it is you have to go into the filter itself into the port members tab and disable the port there. Then go back and change the diff serv settings on the physical port.

Finally go back into the filter tab and re-enable the port membership

 

[mucka]

thanks wookie27 , that was the fix ,much appreciated.

mucka