partner r5 page port?

[endlesswinter]

On the partner acs r5 what is the code you punch in on phone to access page port?

 

[1043]

Read following thread.

http://www.tek-tips.com/viewthread.cfm?qid=1180054

 

[TouchToneTommy]

Intercom 70

(Intercom *70 for the Page Port, AND, any extensions programmed into calling group 1)

 

[endlesswinter]

thats what I thought it was, when I dial this I get a busy signal even with nothing plugged into page port. I power cycled system and no luck. I supose it could be a bad card. Is there anything else I might try first?

 

[1043]

What do you have hooked up to the page port?

 

[endlesswinter]

A page system was hooked up. I pulled the rj11 plug out of the page port on the processor and plugged it into a tone generator this broadcast a tone across the pa system. with the page port still unplugged from the processor I dial intercom *70 and get a busy signal.

 

[TouchToneTommy]

Since you are dialing *70 (simultaneous page), do you have any multiline sets in calling group 1?

 

[1043]

Like TTT said. unless you have telephone extensions in calling group 1.
What happens if you just hit INTERCOM 70.

 

[1043]

#617 tells the system what line you are going to use for paging.Even though you can use any line port for paging on an R7 use line 5, it is a true paging port. Program #617 first before you program #104.

When programmed correctly
int 70 will page overhead
int *70 will page overhead and everyone in group one.
int *71 will only page group 1
int 71 will ring group 1

 

[1043]

Ignore the first paragragh. Thats for ACSR7.

 

[phoneguyjr]

I have had this problem before and it was fixed by assigning the phones in calling group one. #502

 

[endlesswinter]

Thanks alot that worked!