PARTNER II QUESTION

[aarenot]

I have a customer with a partner 2, twin cabinets, and (6) 206E cars, and the two processor cards only. I have to add a 206E to the system. The VM unit is the PC based mail using 4 ports to inteface with the system. I would normally make the VM ports be the last ones on the system, but since this is just an analog ext interface, and not a VM card going into the cabinet slot, is this really needed?

Any other advice would also be welcome, as I do not work on partner 2's that much since I do not even see them in the field much anymore.

Thanks for your advice in advance.

 

[skip555]

with the pc based partner mail I put the ports anywhere

on something that old I like to space the ports out between a couple of 206 cards (in case a power supply takes a 206 out you still have some active VM ports

I also keep them on the first cabinet in case the expansion goes down

 

[TouchToneTommy]

Only reason to move them would be the hole in the dial plan. If that doesn't matter, I'd just leave them alone.

 

[aarenot]

THANKS FOR YOUR RESPONSES